Residential Furnace & Duct Cleaning
COMPRESSED AIR METHOD
FURNACE AND DUCT CLEANING
Air duct cleaning – 200/250 psi (pounds per sq. inch) of compressed air
is used to air blast all Hot & Cold air ducts.
PULL with powerful big vacuum hose (14,000 CFM Suction) from inside your furnace
PUSH with compressed air, spray wands or skipper lines each vent individually
AGITATE with flexible skip lines through the plenums.
Check the Bearing, Belts & Pumps
Examine & Clean the Electronic Ignition System (If applicable)
Examine the Heat Exchanger
Check and Clean the Fan & Motor
Clean & Adjust the Burner Assembly
Pilot Light Safety System Test & Adjustment
Check for visible Gas Pipe Leaks
Check the Furnace Controls & Exhaust
Clean, Check & Adjust Burners & Pilot Light
Test for Carbon Monoxide
Cleanup of Permanent Filter or Replacement of Standard Air Filter
Check Electronic Air Cleaners (If applicable)
THREE METHODS OF CLEANING YOUR VENTILATION SYSTEM
(1) COVENTIONAL “BLOW GUN” METHOD
Commercial grade truck mount vacuum attached directly to your furnace & duct system
drawing on 14,000 CFM. High Pressure air hoses with 210 psi of compression air is used
to blast all hot and cold air vents down to main duct line. Reverse air skipper lines are used
to agitate and move dust and debris to our vacuum and out of he house.
Recommended for routine maintenance every 1-2 Years
(2) FORWARD “SKIPLINE” METHOD
Includes “CONVENTIAL METHOD” along with a forward blowing air line moved down every
vent. The Forward skip line ball swirls, agitating and moving dust & debris along vent lines.
(ADDITIONAL $60.00 PER FURNACE, NO ADDITIONAL EXTRA VENT CHARGE ABOVE OUR REGULAR PRICE)
Recommended for cleaning between 3-5 years, or after light construction or renovation
(3) BRUSH METHOD THE ULTIMATE SYSTEM
First: we power vacuum out the entire duct work system.
Second: all vent line are scrubbed with our Silica Carbide rotary brush system. With your heating
system still under suction, our technicians will brush the inside of the ductwork. This includes the side,
tops, and bottoms of your furnace ducts from the register all the way to the main lines, removing the
caked on dirt and dust. This procedure is then duplicated on both the hot and cold main lines.
Third: we vacuum your system again removing all loose debris.
(ADDITIONAL $110.00 PER FURNACE, ADDITIONAL $3.00 PER EXTRA VENT CHARGE ABOVE OUR REGULAR PRICE)
Recommended for houses that have not been cleaned for 5 years or after
moderate/heavy construction or renovation